Award-Session Accessories & Spares
Replacement SESSION Badge
Original plastic injection moulded, silver on black -
Approx 10 x 5cm
Session Badge £4.75/ea:
Add to Cart
___________________________________________
SG75-EB150 Power Module
Replacement power module for ALL 1980s style Sessionette
amplifiers made between 1981 and 1988. (Those with the control panel on the TOP of the amp!) Is NOT equipped with RetroTone™ speaker drive.
Professional fitting reqired.
Image may differ from actual supplied
This module is for the 1981-1988 Sessionette ONLY! It does not fit the latter 1997 & onward Sessionette, RetroTone, AceTone, Stockton or Punk amplifiers
SG75-EB150 - Price: £59.95 - Add to Cart ___________________________________________
2014-Present BluesBaby:22 & BluesBaby:45 Power Module
(with RetroTone™ speaker drive)
This is the correct replacement RetroTone™ power amp module for both BB22 and BB45 amp models.
Professional fitting reqired.
Designed specially for guitar amps driving an 8 ohm load (cone speakers only). Equipped with RetroTone™ 'Constant Current' speaker drive method for an authentic 'tube amp' warm tone with 'that' top end sparkle
RetroTone™ Class AB - behaves exactly like a
tube amp
driving a typical guitar speaker!
-
Brilliant for powering Modelling Pedals... RetroTone™ gives them that 'real amp in the room' vibe! Unlike regular SS power amps
-
Signal Input: Needs about 2V rms input signal to drive it to full output into an 8 Ohm load
-
For 22 Watts output it requires power derived from an 80VA transformer with 18-0-18VAC outputs featuring a bridge rectified DC output with 2 x 2200uF/50VDC filter capacitors
-
Must be mounted to a heatsink of no less than 1.3W/°C employing heat transfer paste between the power chip and the heatsink
-
Short circuit and themal run-awy protected.
PM22/45 Power Module - Price: £35.00 - Add to Cart
___________________________________________
SG75-TX230 & SG75-TX115
This is the correct transformer for ALL 1980s style Sessionette
amplifiers made between 1981 and 1988. It can be supplied to operate on
230VAC or 115VAC supplies. *It is a direct plug-in replacement*.
Note: Fitting is recommended by qualified service technicians only. We
cannot offer any help with DIY repairs on legal grounds.
Sorrry, this item is currently unavailable. We are working on providing an alternative part. Please do not email us enquiries... We WILL show it here once it is available
___________________________________________
8EB2C1B Reverb Tray/Pan
This is the correct replacement reverb unit for ALL Session amplifiers - 1981 to present!
Type 8EB2C1B - Replaces old 8BC2C1F previously fitted
Note: Fitting is recommended by qualified service technicians only. We
cannot offer any help with DIY repairs on legal grounds.
This module is for the 1981-1989 Sessionette and latter 1997 & onward Sessionette, RetroTone, AceTone, Stockton & BluesBaby amplifiers
8EB2C1B Tray Price: £27.00: Add to Cart ___________________________________________
1980s
Sessionette:75 Foot Switch
Discontinued
SG75-FS2 was a 'plug-in'replacement Channel & Reverb foot switch for all 1980s Sessionette:75 amplifiers made between 1981 and 1989.
Note: For a replacement please visit: http://www.brightonion.co.uk/sessionette-footswitch/
___________________________________________
1980s Sessionette:75 Replacement Pots
We are not able to supply the original ¼" 'D' shaft pots now. They are no longer made.
___________________________________________
1980s Sessionette:75 Replacement Knobs Set
For ¼" D shaft knobs only, as all the amps had originally fitted. These knobs are a little taller, as the originals are not available now.
SG75 Knob Set - Pk 10/£16.95: Add to Cart
___________________________________________

1980s Sessionette:75 Replacement Handle
This is the exact pattern as used in the 1980s! Will fit many other Session amp models too!
Same as standard handle used on BluesBaby™ 22 & 45 amps - single visible M5 screw mount end cap type. Comes complete with new M5 machine screws.
SG75 Strap Handle Price £5.00: Add to Cart
___________________________________________
SG:75 M5 x 30 Chassis mounting screw with cup washer - Pk 10
Price: £4.00: Add to Cart ___________________________________________
M5 'T' nuts for mounting speakers to baffle, etc - Pk 10
Price: £4.00: Add to Cart ___________________________________________
|